About this item
Genuine Apple AirPods Charging Case (Model A1602) only.
This listing is for the charging case only. No left or right earbuds are included.
The charging case has been tested and is fully working. It shows cosmetic signs of previous use including scratches and general wear from everyday use, as shown in the photographs, but functions as intended.
Compatible with Apple AirPods 1st Generation and Apple AirPods 2nd Generation.
Included:
Genuine Apple AirPods Charging Case A1602
Not Included:
Left earbud
Right earbud
Charging cable
Original packaging
Please check compatibility with your AirPods before purchasing.
IMPORTANT – REPLACEMENT CHARGING CASE SETUP & COMPATIBILITY
Model: A1602 – Apple Lightning Charging Case for AirPods 1st & 2nd Generation.
COMPATIBILITY: The A1602 charging case is compatible with:
- AirPods 1st Generation – A1523 and A1722
- AirPods 2nd Generation – A2031 and A2032
The A1602 case can therefore be used with either a complete pair of AirPods 1st Generation or a complete pair of AirPods 2nd Generation.
IMPORTANT: Although this charging case supports both generations, AirPods from different generations cannot be mixed to create a working pair. Both earbuds must be from the same compatible generation.
This case is NOT compatible with AirPods 3, AirPods 4, AirPods Pro or other AirPods models.
Please check the model numbers printed on both of your existing AirPods before purchasing.
The A1602 is a wired Lightning Charging Case. It charges through the Lightning port on the bottom of the case. The status light is located inside the case.
When fitting your existing AirPods into a replacement charging case, the AirPods and replacement case may need to be synchronised before they will pair correctly. A flashing amber/orange status light during initial setup does not necessarily indicate that the replacement case is faulty.
PLEASE FOLLOW THIS SETUP PROCEDURE:
1. Place both compatible AirPods into the replacement A1602 charging case.
2. Connect the charging case to a power source using a Lightning cable.
3. Close the lid and leave the case connected to power for 20 minutes.
4. Open the lid.
5. If the status light is flashing white, continue to step 7.
6. If the status light is not flashing white, keep the lid open and press and hold the setup button on the back of the case for approximately 15 seconds, until the status light flashes amber and then white.
7. With the status light flashing white, close the lid.
8. On your iPhone or iPad, go to Settings > Bluetooth. If your AirPods are already listed, tap the information button next to them, select Forget This Device, and confirm.
9. Open the charging case with both AirPods inside and go to the Home Screen of your iPhone or iPad.
10. When the AirPods setup animation appears, select Connect, then Done.
IMPORTANT
Please complete the above replacement-case setup procedure before concluding that the charging case is faulty.
If you experience a problem after completing the procedure, please contact us and provide the model numbers printed on both of your AirPods so that compatibility can be checked.
